Only 8 spots left$15 $2/seat/month for life for the next 8 founding teams.Claim your spot →

Glossary

What is a SIP trunk?

A SIP trunk is a virtual phone line that connects a business phone system, such as a PBX, to the public phone network over the internet, using the Session Initiation Protocol (SIP). It is what replaced the copper and PRI lines older systems used. A trunk can carry many calls at once, its numbers can be ported in, and it is usually billed per minute or per channel.

Updated · Reviewed by Jaffar Jawed

Key takeaways

  • SIP is the signaling protocol defined in IETF RFC 3261; a SIP trunk is a carrier service built on it.
  • Twilio Elastic SIP Trunking lists US outbound calls at $0.01 a minute to the 48 contiguous states and inbound calls to local numbers at $0.0034 a minute (checked November 2026).
  • Twilio prices Elastic SIP Trunking per minute rather than per channel, while many carriers sell a fixed number of channels; Twilio still applies a calls-per-second limit to how fast new calls start.
  • A SIP trunk connects a phone system to the network; a softphone or desk phone is still needed for people to talk.

What is a SIP trunk?

A SIP trunk is a virtual phone line that connects a phone system to a carrier over the internet using the Session Initiation Protocol. A trunk, in telephone terms, is a line that carries many calls between two switches. A SIP trunk does the same job in software. Your phone system sends a SIP INVITE to the carrier saying which number to call, the two sides agree on an audio codec, and the voice travels as RTP packets. Incoming calls arrive the other way: the carrier sends an INVITE for one of your numbers, and the phone system rings the right desk or softphone. The protocol is specified in RFC 3261.

Capacity is counted in channels, or concurrent calls. A trunk sold with 10 channels can carry 10 calls at once, whatever the number of phone numbers on it. Some cloud carriers do not cap channels and charge only per minute. Security comes from IP allow-lists or credentials, plus TLS and SRTP to encrypt signaling and audio, which not every trunk switches on by default. Twilio’s Elastic SIP Trunking docs describe Secure Trunking with TLS 1.2 or later for signaling and SRTP for media, and say that once it is enabled, unencrypted calls are rejected; the same docs list calls per second as a separate trunk setting, so a channel count is not the only limit to plan for.

How does a SIP trunk work?

A SIP trunk sits between your phone system and a carrier. On an outbound call, a phone on your system dials a number; the PBX sends a SIP INVITE to the carrier’s address with the called number and your caller ID; the carrier replies with ringing and answer messages; and audio flows as RTP packets until either side sends BYE. The carrier is the part that reaches mobiles and landlines, and it signs the call for STIR/SHAKEN caller ID authentication.

Inbound works in reverse: the carrier receives a call to one of your numbers and sends it down the trunk to your PBX, which routes it by extension, menu or queue. Each trunk is configured on both ends: the carrier’s address and authentication on your side, and your public IP or domain on the carrier’s side. Codecs such as G.711 or Opus must match on both ends, or calls connect with no audio.

How much does a SIP trunk cost?

Pricing is either per channel, a monthly fee for each concurrent call with minutes included or metered, or purely per minute with no channel limit. Twilio’s Elastic SIP Trunking is per minute; the table shows its US list prices, checked November 2026 on Twilio’s SIP trunking pricing page. Numbers on the trunk are billed monthly, and 911 service has its own charge.

Twilio Elastic SIP Trunking US list prices (checked November 2026)
ItemPriceNote
Outbound call, 48 contiguous states$0.01 a minuteAlaska and high-cost zones cost more
Inbound call to a local number$0.0034 a minuteToll-free inbound is $0.0130 a minute
Local phone number$1.15 a monthToll-free numbers are $2.15 a month
Call recording$0.0025 a minuteStorage $0.0005 a minute a month
Emergency calling (911)$0.75 a month per numberA registered address is required

How is a SIP trunk different from BYOC or a cloud dialer?

These solve different problems. A SIP trunk connects a phone system you run to a carrier, while BYOC connects a carrier you already use to Twilio’s programmable voice. A cloud dialer needs neither: it places calls through a voice platform’s API, often with TwiML instructions, and reps talk through a browser.

For a sales team without a PBX, a trunk adds equipment to manage without adding anything to the calls. For a company with a PBX, call center software or a contact-center platform that speaks SIP, a trunk is how those systems reach the phone network at a per-minute rate. Twilio’s outbound phone-leg rate for its programmable voice is $0.014 a minute in the US; Twilio’s cost per minute explains how the legs add up.

What SIP trunk mistakes do teams make?

Most SIP trunk problems appear either at setup, when firewalls and codecs are first tested, or under load, when the busiest hour exceeds what was planned. These are the usual causes.

  • One-way or no audio from NAT and firewall settings that block RTP; open the carrier’s media ports or use a session border controller.
  • Too few channels, so the busiest hour gets busy signals.
  • Leaving the trunk open to the internet without IP allow-lists, which invites toll fraud.
  • Mismatched codecs between the PBX and the carrier.
  • No registered 911 address on numbers people may dial emergency services from.

When do you not need a SIP trunk?

If you do not run a phone system, you probably do not need a trunk. A small sales team that calls from a browser can use a cloud dialer on a voice platform, which handles the connection to the phone network without SIP configuration, firewall rules or channel planning. Trunks make sense when you already own a PBX or call-center system, need many concurrent channels at wholesale rates, or have a telecom engineer to manage them. Teams moving numbers to a voice platform can port numbers to Twilio instead.

How does a SIP trunk relate to Rapidialer?

Rapidialer does not use a SIP trunk. It is a browser softphone that places calls through Twilio Programmable Voice in your own Twilio account: connecting Twilio creates an API key and a TwiML app there, and calls run between the rep’s browser over WebRTC and Twilio’s network. You need no PBX, trunk, codec or firewall setup, and Twilio bills the minutes to your account. If your company runs a PBX on a SIP trunk, Rapidialer sits beside it rather than connecting to it.

SIP trunk: questions and answers

What is the difference between SIP and a SIP trunk?

SIP, the Session Initiation Protocol, is the set of rules phones and servers use to start, change and end calls over IP networks. A SIP trunk is a service a carrier sells that uses SIP to connect your phone system to the public phone network. SIP is the language; the trunk is the line that speaks it.

How many SIP channels do I need?

Enough for the most calls you have at the same moment, not the number of people or phone numbers. Count peak simultaneous calls from your phone system’s reports, or estimate from your busiest hour, and add a margin. Twilio’s Elastic SIP Trunking does not sell channels, so the question there becomes your PBX’s capacity rather than the trunk’s.

Can I keep my phone numbers when I switch to a SIP trunk?

Usually yes, by porting them to the new carrier. Porting moves the number from your old provider to the new one and typically takes days to a few weeks, depending on the carriers and the number type. Keep the old service active until the port completes, so calls keep arriving during the switch.

Is a SIP trunk cheaper than a phone line?

For most businesses, yes, because a trunk shares capacity across many calls and is billed per minute or per channel, without the fixed cost of physical lines. At Twilio’s list price of $0.01 a minute for US outbound calls, 5,000 minutes cost $50. Your total also includes numbers, 911 service, your phone system and the internet connection the trunk relies on.

Do I need a PBX to use a SIP trunk?

You need something that speaks SIP on your side: an on-premises PBX, a cloud PBX, a session border controller, call-center software or a contact-center platform. A softphone alone can register with a PBX, but most trunks are not built for individual softphones to connect to directly, so very small teams often find a hosted phone service or cloud dialer simpler.

Is SIP trunking secure?

It can be, if you switch on the protections. Use TLS to encrypt signaling and SRTP to encrypt audio, restrict the trunk to known IP addresses, use strong credentials, and set spending or destination limits to stop toll fraud. Twilio’s Elastic SIP Trunking documents Secure Trunking with TLS and SRTP, but you still have to enable it on both ends.

Start today

Import your list and make your first call today

Connect Twilio, upload a CSV and start dialing.